Digiten G1" Water Flow Sensor Hall Effect Sensor Flow Meter 1-60L/min Compatible with Arduino, Raspberry Pi and Reverse Osmosis Filters
Digiten G1" Water Flow Sensor Hall Effect Sensor Flow Meter 1-60L/min Compatible with Arduino, Raspberry Pi and Reverse Osmosis Filters
Specifications: Frequency: F = 4.8 Q (L / Min) Error: 2%, current cannot exceed 10mA, 450 output pulses/liter F=constant flow units (L / min) Time (seconds) Flow range: 1-60 L/min Maximum Current: 10mA (DC 5V) Operating voltage: DC 5-18V Load capacity: ≤ 10mA (DC 5V) Operating temperature: ≤ 80℃ Humidity: 35%-90% relative humidity Allow compression: water pressure 1. 2 MPa below. Insulation resistance: > 100 m ohm. Storage temperature: -25 to 80 °C. Storage humidity: 25-95% relative humidity. Output waveform: square waves, output pulse signal. Cable length: 15 cm. Package contents: 1 x flow meter
Product Features
- Flow range: 1-60 l/min, working voltage range: DC 5-18 V.
- Small size, easy to close install, all materials are in line with RoHS testing standards.
- Waterproof, heat-resistant, pressure-resistant, cold-resistant.
- Output waveform: square waves, output pulse signal.
- Sensor: Hall effect.