Cable Pass-Through Kit Compatible with Starlink, Zip-Ties and Bit Included
Cable Pass-Through Kit Compatible with Starlink, Zip-Ties and Bit Included
Running a satellite internet cable into your house means drilling a hole through your exterior wall. What happens next is the difference between an install that looks finished and one that looks improvised. This kit handles the whole job. The 1" paddle bit cuts the pass-through. Two rubber grommets seat into it, one from the outside and one from the inside, meeting within the wall cavity. Because they install as a pair rather than a single fixed-length sleeve, the same kit works on thin siding and on thick insulated walls alike — you aren't measuring your wall depth before ordering and hoping. Each grommet is split down its length. That relief slit lets you open the sleeve around a cable that's already been run and terminated, so a factory connector never has to be cut off and re-terminated. Thread the cable, wrap the grommet, press it home. From there, 30 P-style clips with screws secure the cable down the wall at proper intervals, and 10 zip ties bundle the run at the mast. The included 3/8" twist bit handles pilot holes for the clip screws. Weather-resistant rubber seals the opening against wind, water and insects. The result is a cable entry that looks like it was done on purpose. WHAT'S IN THE BOX 4 x wall grommets (fits a 1" hole) 30 x P-style cable clips with screws 10 x 6" black zip ties 1 x 1" paddle bit 1 x 3/8" twist bit Note: two grommets form one complete pass-through. Four grommets cover two cable entry points.
Product Features
- EVERYTHING IN ONE BOX No second trip to the hardware store. Includes 4 wall grommets, 30 cable clips with screws, 10 zip ties, a 1" paddle bit and a 3/8" twist bit. Drill, seal and secure the whole run with what's in this kit.
- TWO-PIECE DESIGN FITS ANY WALL One grommet seats from outside, one from inside, so a single pass-through seals cleanly through siding, sheathing and drywall. No gap, no exposed hole, no guessing at wall thickness before you buy.
- SPLIT SLEEVE WRAPS AN INSTALLED CABLE A relief slit runs the full length so the grommet opens around a cable already terminated. No cutting connectors, no re-running line. Fits a 1" drilled hole and cables up to [X]mm.
- 30 CLIPS FOR A CLEAN RUN Most kits give you five. Thirty P-style clips with screws let you space fasteners properly along the full descent from dish to wall, so the cable stays flat and straight instead of sagging between anchors.
- BUILT FOR PROS AND FIRST-TIMERS Weather-resistant rubber seals against wind and water intrusion. Straightforward enough for a first install, complete enough that installers doing several a week aren't resupplying between jobs.