SoloGood 5.8Ghz 2W VTX FPV Transmitter Over 20Km Range TS582000 5.8G 2000MW 8CH Video Transmitter with 5dbi SMA Antenna for FPV Racing Drone Quadcopter
SoloGood 5.8Ghz 2W VTX FPV Transmitter Over 20Km Range TS582000 5.8G 2000MW 8CH Video Transmitter with 5dbi SMA Antenna for FPV Racing Drone Quadcopter
Transmission Characteristics:Output Power:2000mWOperating Voltage:8V-25V(2S-6S)Operating Current:800mA(12V testing)Channel :24CH VideoFormat: NTSC/PALOutput Voltage:5V/Input Voltage (Jumper cap selection)Antenna Interface: SMA (External thread internal pin)Weight:30g Output Voltage:Two output voltages, It can supply power to 5V and wide voltage cameras, Select the output voltage through a three-point jumper pad, and check the wiring scheme drawing for operation details. 1.The jumper pad is short circuited to the two points on the right, and the output is 5V at this time. 2.The jumper pad is short circuited to the left two points, and the input voltage of the power supply is output at this time. Three schemes of actual wiring diagram: (The picture above shows )Wiring scheme 1: It is suitable for micro camera with voltage of 3.3-5v and current less than 100mA. If there is no condition to verify that the camera meets the above voltage and current conditions, this wiring method is prohibited, otherwise there is a great risk of damaging the transmitter. (The picture above shows )Wiring scheme 2: It is suitable for 5-25v wide voltage camera, and this scheme is universal. (The picture above shows )Wiring scheme 3: It is suitable for the camera of scheme 2 which cannot be used when the voltage is low and scheme 1 cannot be used when the current is high, for example, a moving camera. This wiring scheme is universal and basically applicable to all cameras. The disadvantage is that the wiring is a little more complicated.
Product Information
- Product Name:new SoloGood 5.8Ghz 2W VTX FPV Transmitter 2000MW High Power born for fpv racing drone Quadcopter.
- Newly upgraded power supply solution, using synchronous rectifier dcdc solution, no more skew, image quality has been greatly improved.
- Light weight, double-sided heat sink, increase the power protection circuit to reduce the instantaneous easy burn phenomenon.
- Increase the column fixed SMA interface, more resistant to bombing.
- Newly upgraded to silicone wire, the wire is soft, not easy to break, can pass a large current.