Flexx Boot FB4000 Universal Replacement Rack & Pinion Steering Boot 1 pack
Flexx Boot FB4000 Universal Replacement Rack & Pinion Steering Boot
The Flexx Boot FB4000 is a universal replacement boot for rack and pinion steering mechanisms. This installation kit includes an installation cone and two wire straps. The FB4000 is compatible with over 97% of the world's cars that feature rack and pinion steering. The boot is made of rugged, specially formulated high stretch rubber. Rack & Pinion Boot Fitting Instructions The Rack & Pinion Boot Kit includes an installation cone that allows for the replacement of the boot without removing the tie rod end. Realignment of the vehicle is not necessary after installation. 1- Remove the outer tie rod retaining nut and detach from spindle 2- Remove the old boot and clean the assembly 3- Cut the boot to the next diameter smaller than the steering rack body 4- Position the installation cone over the tie rod end threads 5- Lubricate the inside of the boot and cone 6- For easier installation, roll the boot back on itself, push it on the rack, and then push the rolled part onto the rack 7- Make sure to position the vent downwards so that any moisture drains out 8- Install tie straps and grease fittings. Reinstall the tie rod end and tighten the ball joint retaining nut to manufacturers specs. Note : The rack & pinion boot can also be installed in the traditional way by separating the outer tie rod from the inner tie rod. This method might necessitate a wheel alignment.
Product Features
- One year guarantee.