AEDIKO 4pcs L298N Motor Driver Controller Board DC Dual H-Bridge Robot Stepper Motor Control Module with 60pcs Jumper Wires
AEDIKO 4pcs L298N Motor Driver Controller Board DC Dual H-Bridge Robot Stepper Motor Control Module with 60pcs Jumper Wires
Description
Specification:Module : Dual H Bridge Motor Drive ModuleWork Mode : H Bridge Drive (Double Road)Control Chip : ST L298N Dual H-Bridge Driver ChipLogical Voltage : 5VDrive Voltage : 5V-35VLogical Current : 0mA-36mADriving Current : 2A (MAX Single Bridge)Maximum Power : 25WFeatures:Dual H Bridge Motor Drive Module Uses L298N as the Main Drive Chip, with Strong Driving Ability, Low Heat and Strong Anti-Interference AbilityThrough L298N Module Can Use the Built-in 78 M05 Drive Power Supply, In Order to Protect the Voltage Regulator Chip,Make Sure the Driving Voltage is Greater Than 12V and the External Power Supply 5V LogicThis Module Uses a Large Capacity Filter Capacitance, a Continuation Protection Diode, Can Improve ReliabilityNotes:Application: When your Driver is 7V-12V, You Can Enable the On-Board 5V Logic Supply. When Using the On-Board 5V Power Supply, the + 5V Power Supply in the Interface IS Not Input Voltage, but it Can Draw 5V Voltage for External UseUnconventional Application of High-Voltage Driver: When the Driving Voltage is Higher Than 12V, Less Than or Equal to 24V, for Example, to Drive a Motor With Rated Voltage of 18V, the Jumper Cap with 5V Output Enabled On-Board Voltage Must be Pulled Out and then Outside the 5V Output Port Connect 5V Voltage to L298N Internal Logic Voltage SupplyPackage Contents:4x L298N Motor Driver controller Board Module1x Jumper Wires Kit(Male to Male Wires(20Pin)1x Male to Female Wires(20Pin)1x Female to Female(20Pin)
Features:
- L298N Motor Driver Module Uses L298N as Main Driver Chip, Strong Driving Ability,Low Heat and Strong Anti-Interference Ability
- Double H Bridge Design:L298N Motor Comes With Dual H Bridge Which Can Drive one 2-Phase Stepper Motor, one 4-Phase Stepper Motor or Two DC Motors at Same Time
- Easy to Use: L298N Board No Assembly Required,Just Wire Up Motors and Power,Very Easy to Install
- Wide Application:L298N Module Works for DIY Smart Car Robot Power etc.
- Package Contents: Your will get 4pcs L298N Dual H Bridge Stepper Motor Driver Boar and 60pcs Jumper Wires Kit(Male to Male Wires(20Pin),Male to Female Wires(20Pin),Female to Female(20Pin))