5PCS TCA9548A Expansion Board I2C IIC Multiplexer Breakout Board 8 Channel Expansion Board for Arduino
5PCS TCA9548A Expansion Board I2C IIC Multiplexer Breakout Board 8 Channel Expansion Board for Arduino
Description
Product Parameters:Working voltage: 1.65V~5.5VIIC clock frequency: 0 ~ 400KHzWorking environment temperature: -40 ° C ~ 85 ° CSmall board size: 31.5mm21.4mm with two M3 mounting holes.Instructions For Use:The /RESET, SDA, SCL, A0, A1, and A2 pins on the small board are connected to the pull-up 10K resistor, no need to connect externally.Product Features:-The adapter is connected to an I2C device with multiple identical addresses on the same I2C port on the main control board for normal communication and use.-Finally, a way to get up to 8 same-address I2C devices hooked up to one microcontroller - this multiplexer acts as a gatekeeper, shuttling the commands to the selected set of I2C pins with your command.-The default address of this expander is 0x70, the address can be changed, and can be set within 0x70~0x77 according to your needs. In theory, 8 expanders can be cascaded in the address of 0x70~0x77, and each expander can connect 8 devices with the same address. This realizes the same I2C port and connects 64 devices with the same address and uses them normally.-Compatible with IIC bus and system management bus (SMBus), active low reset input, support for hot insertion, low standby current, no glitch during power-up, support for voltages between 1.8V, 2.5V, 3.3V and 5V buses Level shifting.-Like all Adafruit breakouts, we put this nice chip on a breakout for you so you can use it on a breadboard with capacitors, and pullups and pulldowns to make usage a snap. Some header is required and once soldered in you can plug it into a solderless-breadboard. The chip itself is 3V and 5V compliant so you can use it with any logic level.Package Included:5 x TCA9548A I2C IIC Multiplexer Breako
Features:
- Chip: TCA9548A
- Interface: I2C IIC; Selectable I2C address: 0x70-0x77
- Working Voltage: 1.65-5.5V
- Max Clock Frequency: 400KHz
- Instructions For Use: The /RESET, SDA, SCL, A0, A1, and A2 pins on the small board are connected to the pull-up 10K resistor, no need to connect externally.